Waveform installers

SmartSDR Waveform API Feature Description

2018-08-08T21:41:28+00:00August 5th, 2018|

A description of the SmartSDR Waveform API used for adding and integrating modulation/demodulation modes directly into SmartSDR. This datasheet describes the following available Waveforms: Codec2 (FreeDV) D-STAR®

D-STAR Waveform How To Guide

2018-08-08T22:40:48+00:00August 5th, 2018|

The D-STAR® Waveform How-To Guide describes the basic operation of the ThumbDV™ D-STAR (DSTR) mode that can be added to any FLEX-6000 Signature Series software defined radio. Note: The D-STAR waveform requires an NW Digital Radio ThumbDV (DV3000U) USB device that is plugged into the USB port on the back of the FLEX-6000 to provide [...]

ThumbDV D-STAR Waveform

2018-08-05T20:01:24+00:00August 5th, 2018|

The ThumbDV D-STAR Waveform Installer adds the D-Star mode to FLEX-6000 Signature Series SDRs - D-Star digital voice and data protocol specification for HF and VHF+ amateur radio, developed by the Japan Amateur Radio League (JARL). D-Star uses frequency-division multiple access and minimum-shift keying in its packet-based standard. NOTE: To utilize D-Star with the FLEX-6000 [...]

FreeDV Waveform

2018-08-05T20:01:46+00:00August 5th, 2018|

The FreeDV Waveform Installer adds the FreeDV mode to FLEX-6000 Signature Series SDRs - FreeDV is a free, open source, digital voice communications system for HF amateur radio, which uses the CODEC2 low bit rate VOCODER (Voice Coder Decoder) developed by David Rowe, VK5DGR.

FreeDV Waveform How To Guide

2018-08-08T22:41:45+00:00August 5th, 2018|

The FreeDV Waveform How-To Guide describes the basic operation of the FreeDV (FDV) mode based on CODEC2 that can be added to any FLEX-6000 Signature Series software defined radio.